This 1156mm/45.5'' long, full-size, Slimline II cargo roof rack kit contains the Slimline II Tray, Wind Deflector and 2 Low Profile Foot Rails to mount the Slimline II Tray to your Toyota Tacoma 2005+. Easily installs using the existing factory mounting points. No drilling required. Compatible with ''shark fin'' antenna.KRTT005T - Toyota Tacoma (2005-2023) Slimline II Roof Rack Kit / Low Profile - by Front Runner Consisting of: 1x FATT004 - Toyota Tacoma (2005-2023) Foot Rails/Low Profile1x RRSTD06 - SLII Tray - 1255mm(W)X1156mm(L)1x WDST010 - Wind Deflector 20mm Lip Narrow Pair /1255mm(W)Material Used:Black epoxy powder - coated T6 aluminiumHigh strength steelApproximate Installed Weight: 24.51kg (54.04lbs) The t-slots on the tops and bottoms of the rack tray slats and edge profiles accommodate standard 8mm bolts.To determine the approximate height from your vehicle's roof to the top of your Slimline II Roof Rack, add the height of the Slimline II Tray (50mm/2'') to the height of the Foot or Grab-on Foot listed above.If your Slimline II Roof Rack kit uses Legs, add the height of the Slimline II Tray (50mm/2'') to the height of the Legs to determine the height of the rack from your vehicle's rain gutters.If your Slimline II Roof Rack kit uses Foot Rails, add the height of the Slimline II Tray (50mm/2'') to the height of the Foot Rails to determine the height of the rack from the crown (highest point) of the vehicles roof.Shipping Dimensions:Width: 455mm (18'')Length: 1610mm (63'')Height: 240mm (9'')Shipping Weight:Weight: 24.53kg (54lbs)This 1156mm/45.5'' long, full-size, Slimline II cargo roof rack kit contains the Slimline II Tray, Wind Deflector and 2 Low Profile Foot Rails to mount the Slimline II Tray to your Toyota Tacoma. Easily installs using the existing factory mounting points. No drilling required. Compatible with ''shark fin'' antenna. All Front Runner Rack Kits contain installation instructions, as well as all the components needed to mount the Slimline II Tray to your vehicle. All Front Runner Racks are backed by a Limited Lifetime Warranty*Note: This kit will allow your sunroof to open completely, but it will not allow the sunroof to be operated in tilt/vent mode. If you would like to operate the sunroof in tilt/vent mode, you can use KRTT002T, provided that you do not mount a table underneath.Note: Some side mount accessories are not suited for low profile foot rails such as JADA010 and RRAC103.