Ford Maverick (2022-Current) Double Load Bar Kit

Transform your Ford Maverick's load bed into the ultimate cargo-carrying adventure truck with this Double Load Bar Kit. Like on our roof racks, you can slide a host of Front Runner rack accessories into the top or bottom of the load bar's T-slots.KRFM014 - Ford Maverick (2022-Curr) Double Load Bar Kit

Consisting of:2x LASS028 - Pick-Up Roll Top Leg Mount1x LBSK016 - Roof Load Bar Pair 1425mm(W)1x RRAC977 - Pickup Load Bed Bolt Kit / 40MM1x TRBU002 - Pick-Up Load Bed Tracks / 1200mm(L)

Material Used: Black epoxy powder - coated T6 aluminum

Approximate Installed Weight: 10.18kg (22.44lbs)

The t-slots on the tops and bottoms of the slats accommodate standard 8mm bolts.

To determine the approximate height from your vehicle's roof to the top of your Load Bar Kit, add the height of the Load Bar (22mm/ 7/8'') to the height of the Foot, Grab-On Foot, or Strap-On Foot listed above. If your Load Bar kit uses Legs, add the height of the Load Bar (22mm/ 7/8'') to the height of the Legs listed above to determine the height of the rack from your vehicle's rain gutters. If your Load Bar kit uses Foot Rails, add the height of the Load Bar (22mm/ 7/8'') to the height of the Foot Rails listed above to determine the height of the rack from the crown (highest point) of the vehicles roof.

Shipping Dimensions: Width: 160mm (6'')Length: 1530mm (60'') Height: 270mm (11'')Shipping Weight: Weight: 11kg (24lbs)

A set of Pickup Bed Load Bars used to transport gear over the bed of your Ford Maverick. This low profile solution includes 4 Pickup Roll Top Leg Mounts, 2 1425mm Load Bars, 1 set of Load Bed Tracks and fitting instructions. The Load Bars are mounted via Pickup Roll Top Load Mounts that bolt directly onto a set of Load Bed Tracks. Allows for gear to be mounted above the pickup's load bed. The load bed retains its load-carrying ability, while the drop down door functions as usual. Uses the same strong, corrosion-free aluminum slats found in Front Runner Racks. The sliding nut t-slots allow for quick fitting and removal of accessories and equipment on both the top and bottom of the slats. Made from steel and a durable, weather-resistant black powder coated aluminum. Includes all hardware, components and the installation guide needed to fit Load Bars on a vehicle. Note: Drilling is required. For further information on installation, please see the fitment instructions in the INSTALL tab.

Note: The load per Load Bars must not exceed 55lbs or 25kg, and ensure the load is distributed evenly. For larger loads, additional Load Bars may be needed, please contact Customer Service for any enquiries.